DTF / UV Printer Annual Service - Tier 2

Service Description

Typical Configuration 2–3 printheads Dedicated dampers per head Higher ink throughput Automated maintenance cycles Intended For Production DTF printers Small industrial UV platforms Systems with white ink circulation Technical Scope (What We Actually Do) Ink System & Dampers Individual damper inspection per channel Flow balance comparison between heads White ink circulation verification Identification of partial blockages or pressure imbalance Printhead System Nozzle health mapping across heads Head-to-head alignment check Carriage stability inspection Strike risk assessment under load Maintenance & Pumping Cap-to-head sealing verification Pump pressure stability test Waste system and filters inspection Electronics & Control Head ribbon and connector inspection Static risk and grounding assessment Early-stage board stress identification (non-invasive) Software & Calibration Multi-head alignment calibration White ink ratio and layer verification Firmware and parameter consistency check Outcomes for the Client ✔ Improved colour and white consistency ✔ Reduced head wear ✔ Early detection of pump and damper failure ✔ Increased production reliability Tier 2 Limitations No board replacement No head replacement No full ink flush unless quoted No mechanical rebuilds (Includes up to 2 hours travel time) Please see our full T&C's - https://www.laserprints.co.uk/terms-and-conditions